EN
35
TROUBLESHOOTING
Symptom
Possible cause
Proposed action
The product will
not start.
The power point is without voltage.
Check that the power point is supplied
with voltage.
The carbon brushes are worn.
Contact an authorised service centre in
the event of an electrical fault or fault in
the motor.
Short circuit.
The power switch is faulty.
The product works
slowly.
The saw blade is dull or damaged.
Replace the saw blade.
Speed too slow.
Set a higher speed.
Overheated motor.
Do not press too hard on the product.
Noise.
Mechanical fault.
Contact an authorised service centre.
Winding fault.
Heavy vibration.
The saw blade is not correctly
attached.
Check that the saw blade is correctly
fitted.
Sparks from the
motor.
Blocked carbon brushes.
Contact an authorised service centre.
Short circuit in the winding.
Dirt on the commutator.
