EN
49
battery starts charging. The status light
stops flashing when the battery is fully
charged.
3. Press the lock button and remove the
battery from the charger.
4. Pull out the plug from the power point.
Fault status when charging
• If the status light flashes red when the
battery is put in this means there is a fault
on the battery and/or charger.
– The temperature of the battery is too
high or too low. The charging process
starts when the battery has reached
charging temperature (0 to 45°C).
– Remove the battery from the charger
if the status light continues to flash
red after the battery has reached
charging temperature. Check the
terminals on the battery and charger,
and clean them if necessary. Replace
the battery. The battery is defective if
the same fault occurs again. Replace
the battery or take it to an authorised
service centre to be checked.
– The charger is defective if the same
fault occurs with another battery.
Take the charger to an authorised
service centre to be checked.
MAINTENANCE
NOTE:
Always remove the battery before cleaning
and maintenance.
CLEANING
• When the catcher has been shaken out,
turn it inside out and carefully clean it to
prevent moulding and unpleasant smell.
• A very dirty catcher can be cleaned with
soap and water.
• Rub the zip with dry soap if it is stiff.
• The suction/blower tube can be cleaned
with a brush.
• Dirt can cause the lever to switch mode to
become stiff. In which case, move it back
and forward a few times until it works
normally again.
MAINTENANCE
Take the product to an authorised service
centre, or other qualified personnel, to be
checked and repaired if there are any other
problems. The product does not contain any
parts that can be repaired by the user.
Summary of Contents for 018285
Page 4: ...1 2 3 1 2 3 4 5 6...
Page 5: ...5 6 8 9 7 4...
