Meec tools 015279, Operating Instructions Manual

Page: 21 / 44

EN
21
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Nominal input power 400 W
Pump pressure 0.7 bar
Flow 133 l/min
Lifting height max 7 m
Submersion depth max 7 m
Minimum water level for
manual start 5 mm
Minimum water level for
automatic start 50 mm
Residual level, manual 1 mm
Residual level, automatic 40 mm
Particle size max 5 mm
Water temperature max 35°C
Protection rating IPX8
Cord length 10 m
Connection 1”(R25)/1 1/2"(R40)
Overheating protection Yes
Size L16,5 x W16 x H29 cm
Weight 4.6 Kg
DESCRIPTION
An invaluable accessory when flooding is a
fact. This submersible pump from Meec Tools
is adapted for clean to moderately dirty water,
and has an impressive residual level of 1 mm.
This means it is ideal to use when the house,
for example the basement, has been exposed
to flooding. The pump also has automatic
start/stop, but can be run manually, with a
motor made of aluminium and an impressive
pump capacity of up to 133 litres per minute
(8000 l/h).
USE
CONNECTION OF OUTLET TUBE
1. Screw the outlet tube on the outlet
connection. All the connections should be
sealed with jointing tape.
• Protect electrical connections from
moisture.
• Do not expose the product to
temperatures below 0°C. Make sure that
the product is not run without water.
• Do not pump aggressive liquids or
abrasive material.
• Do not pull the power cord or float switch
cord to move the product, and do not use
them to secure the product from moving.
• The product is only intended for
household use and is not suitable for
commercial purposes.
• The manufacturer cannot accept liability
for personal injury or material damage
resulting from improper use.
IMPORTANT:
The product must be connected to the mains
with a residual current device of max 30 mA.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.