EN
30
MAINTENANCE
WARNING!
• Electrical safety! Pull out the plug before
working on the product.
• Risk of personal injury. Make sure that
the product and all connected devices
are pressureless before working on the
product.
IMPORTANT:
Risk of material damage. All the seals should
be replaced if the product is dismantled.
STORAGE
If there is a risk of frost, dismantle and clean
the product and its accessories and store in a
frost-free place.
IMPORTANT:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.
DISMANTLING AND STORAGE
1. Switch off the product and pull out the
plug.
2. Open the tap on the outlet tube and wait
until all the water has run out.
3. Empty the product by unscrewing the
drain plug (1) underneath the pump.
4. Disconnect the suction tube and pressure
tube from the product.
5. Store the product frost-free (at least 5°C).
TROUBLESHOOTING
WARNING!
• Risk of personal injury. Repairs that are
not carried out correctly can result in the
risk of fatal or serious personal injury
and/or material damage.
9. Switch off the product and pull out the
plug when water comes out in a smooth
flow. Drain the water from the product by
opening the drain on the pump.
FIG. 6
NOTE:
• It is recommended to install a non-return
valve between the suction tube and
pump, so that the water remains in the
suction tube.
• It is recommended to use an intake filter
for best functionality.
• The pump and suction tube should be
connected and filled with water.
• Always check before use that the suction
tube is tight. Bubbles of air in the suction
tube indicate leakage, and can prevent
the product from working properly.
IMPORTANT:
Risk of material damage. Never allow the
product to run dry. Make sure there is always
enough water to pump.
STARTING
1. Plug in the plug.
2. Start the product with the power switch.
3. Open the tap on the outlet tube.
4. Check that water flows out.
If the motor does not start, if the pressure does
not increase or if there are other problems,
switch off the product and pull out the plug,
and try to correct the fault with the help of the
troubleshooting guide.
IMPORTANT:
Risk of material damage. Running the
product for more than 3 minutes with closed
outlet tube – risk of overheating and material
damage.
