EN
42
– Fully pressed switch = top speed for
drilling.
IMPORTANT:
Make sure not to stop the motor when
pressure is applied during drilling or
screwdriving.
DIRECTION OF ROTATION,
RIGHT/LEFT DRIVE
The direction of rotation is set with the selector
for right/left drive over the power switch.
FIG. 6
IMPORTANT:
Only change the direction of rotation when
the motor is off.
Screwing in screws
Set the right/left drive selector to right drive.
Unscrewing screws
Set the right/left drive selector to left drive.
Safety mode
Selector in middle position. The tool will not
start when the selector is in this position. Used
during pause or when changing bits and drills.
IMPORTANT:
Risk of over-screwing because the screw goes
in too deep. Pay attention to the screwing.
If necessary stop and screw the screw by
hand with a screwdriver. Test screw.
GEAR SELECTOR
Two different speeds can be selected with the
gear selector. The speed to use depends on the
material and the planned job, and can be first
tested on a sample piece.
FIG. 7
WARNING!
• Unintentional starting is dangerous.
Put the rotation selector in the middle
position when the tool is switched off.
This blocks the power switch.
• Risk of injury. Wear gloves when putting
drills in the quick chuck.
• Firmly tighten the quick chuck when
putting in tool inserts.
STARTING/STOPPING
FIG. 5
Starting
Press the power switch to start screwdriving or
drilling. Keep the power switch pressed during
screwdriving/drilling. The LED work light goes on.
Stopping
Release the power switch when the screw is
fully screwed in/unscrewed, or when the drill is
out of the workpiece. The LED work light goes
off when the screwing/drilling is finished.
LED WORK LIGHT
The LED work light goes on when the tool is in
use for improved visibility and safer working in
dark spaces. The LED goes off when the power
switch is released.
IMPORTANT:
LED work light. Do not look directly into the
light beam, it can damage your eyes.
WORKING METHOD
Electronic speed control
With the electronic speed control the speed
can be variably adjusted to the actual job.
– Tapping the power switch = low
speed to undo stubborn screws.