EN
24
WARNING!
Vibration levels can deviate from the declared value,
depending on how the tool is used. Suitable precautions for
users must be based on the actual conditions, taking into
account all parts of the operating cycle, such as the time when
the tool is switched off and the idling time, in addition to the
time when the power switch is pressed.
DESCRIPTION
APPLICATIONS
The tool is intended for sawing with the tailstock of straight and
curved sections in wood, plastic and other building material.
With suitable saw blades it is possible to saw off extruding
sections flush with adjacent surfaces.
FIG. 1
1. Saw blade
2. Pad
3. Blade holder
4. Lock ring
5. Locking screws
6. Power switch On/Off
7. Power switch lock (locks power switch in On position)
ASSEMBLY
WARNING!
Switch off the reciprocating saw and pull out the plug before
cleaning or adjusting.
Fitting/replacing saw blades
NOTE:
• Clean the blade holder every time a blade is replaced.
• Always check before use that the saw blade is correctly fitted.
• Wear safety gloves when handling saw blades. Contact with
the saw blade can result in personal injury.
FIG. 2
To fit or replace a saw blade, turn the lock ring (4) 180° clockwise.
Insert the blade in the blade holder (3). Release the lock ring (4)
and check that the tap on the blade holder sits in the hole in the
saw blade. Turn the lock ring back to locked position. If necessary
the saw blade can be turned 180° before fitting it.
Adjusting the pad
FIG. 3
Undo the two locking screw (5) and move the pad (2) to the
required position. Retighten the locking screws (5).
Symbols
Description of symbols used on the product. Familiarise yourself
with them to reduce the risk of personal injury and material
damage.
Read the operating instructions before use.
Use ear protection.
Wear safety glasses.
This product is rated as safety class II. That means
it is fitted with enhanced or double insulation.
The product complies with the relevant EU
directives, and an evaluation method to verify
compliance with these directives has been applied.
WEEE symbol. End-of-life electrical products must
not be discarded with household waste. Recycle
where possible. Check with local authorities or
your local store for information on recycling.
TECHNICAL DATA
Rated voltage, frequency
230 V ~ 50 Hz
Output 710 W
Stroke rate (no load)
0-2800 /min
Stroke length
20 mm
Max cutting capacity in wood
115 mm
Max cutting capacity in plastic
115 mm
Max cutting capacity in steel
3 mm
Sound pressure level
LpA 83 dB(A), K=3 dB
Sound power level
LwA 94 dB(A), K=3 dB
Vibration
22.10 m/s², K=1.5 m/s²
Cord length
2 m
Safety class
II
Weight
2.75 kg
Wear ear protection.
Declared total vibration values are measured in accordance with a
standard test method, and can be used for comparisons between
tools. The value may also be used for a preliminary assessment of
exposure.
Summary of Contents for 000-902
Page 3: ...1 2 3 2 1 5 4 6 7 1 2 3 4 ...
Page 4: ...3 4 5 2 ...