EN
18
Charging the battery
NOTE:
•
The battery must be charged before it can be used with a tool.
•
After charging for the first time, use the tool until the battery is completely discharged.
Repeat this charging and discharging cycle 4 to 5 times.
•
If the LEDs on the charger do not go on when charging:
– check that the charger’s mains adapter is properly plugged into the power point and that
the charger is switched on
– check that the battery is correctly inserted in the charger
1.
Place the battery charger on a level and stable surface. Plug the charger into a 230 V power
point. The red LED on the charger goes on.
2.
Connect the battery to the charger so that it clicks into place. The green LED goes on and
starts flashing, this indicates that the battery is charging. At the same time , the red LED on
the charger remains constantly red.
3.
When the battery is fully charged, after about on hour, the red LED goes off and only the
green LED stays on.
4.
Unplug the charger cord from the power point and remove the battery from the charger.
