MedTalk 1328S, Instructions For Use Manual, Page: 3 / 7

Measuring
Measuring
Measuring Measuring
Human Human Human Human Body- Body- Body- Body- and and and and Ambient Ambient Ambient Ambient temperature temperature temperature temperature measurement measurement measurement measurement
Choose the “Human Body”-, or the “Ambient” measurement symbol with the switch
at units left side when it is powered off.
Non-Contact type forehead measuring mode (Figure 5.1B)
● Press the POWER POWER POWER POWER button and all the icons will appear briefly - Figure 5.2B.
● After that the display shows the last measured temperature - Figure 5.3B.
● When the forehead symbol is displayed on the screen as shown in Figure 5.4B; and the
℃
symbol is blinking, the body temperature can be measured. A voice will ask you to start the
measurement.
● Place the PROBE
PROBE PROBE
PROBE part of the thermometer 5 to 10cm away from the center of the forehead and
press the SCAN
SCAN SCAN
SCAN button. When you hear the beep, the measurement will be finished in 1 second. The
reading will appear as shown in Figure 5.5B. The voice will announce your body temperature and a
blue backlight appears if your body temperature is ok. If your temperature is too high, the backlight will
be red.
● NOTE: Before measuring, please be sure your forehead is dry and clean.
● You can take a new reading once the
℃
symbol starts blinking. A voice will ask you to measure
again.
● The power will shut off within 60 seconds, if you do not switch it off by pressing the POWER button.
Ambient Ambient Ambient Ambient temperature temperature temperature temperature measuring measuring measuring measuring mode mode mode mode (Figure (Figure (Figure (Figure 5.1C) 5.1C) 5.1C) 5.1C)