Medrad Mark 7 Arterion, Operation Manual

Page: 72 / 162

MEDRAD
®
Mark 7 Arterion Injection System
11 - 64
11.2.2 Arm Multi Mode
NOTE:
The term start switch in this section is used to refer to the hand switch, foot switch
or hand controller.
The Arm Multi mode is available only for Single mL/s and Variable Flow Rate protocols. This mode
allows for multiple injections per arming sequence. An injection starts when the operator presses and
holds the start switch. After each injection, the system re-arms if all of the system tests described in
step
3 below pass.
1.
Select the Home tab.
2.
Single mL/s protocols : select Arm Multi (A). Variable Flow Rate protocols : select Arm (B).
Figure 11 - 3: Arm Multi
Figure 11 - 4: Arm Variable
3.
Visually confirm that all air has been purged from the syringe and disposable set, and select
Yes .
NOTE:
There is sufficient volume remaining in the syringe. If there is not sufficient volume
remaining in the syringe for the programmed protocol, the system gives the option
of overriding the programmed volume and using the available volume remaining. If
the operator selects
Yes , the system arms with the new programmed volume. If the
operator selects No , the system will not arm. The operator needs to adjust the
protocol Volume equal to or less than the volume remaining in the syringe.