Medrad Mark 7 Arterion, Operation Manual

Page: 109 / 162

Installation - System and Accessory
16 - 101
16.5.3 Fixed Table Mount Installation
The Fixed Table Mount can be used to mount a Display Control Unit using the Fulcrum Mount Bracket
kit to a bed rail. The Fixed Table Mount bracket is designed to accommodate rails from 1/4” (6.4mm) to
1/2” (12.7mm) thick and 7/8” (22.2mm) high.
NOTE:
The Fixed Table Mount is not intended to support the Injector Head.
1.
Slightly angle the Fixed Table Mount bracket towards the center of the table and hook onto
the top of the accessory rail.
Figure 16 - 19: Attaching the Fixed Table Mount
2.
Rotate bracket away from the center of the table until the Mounting Lever engages with table
rail.
NOTE:
It may be necessary to adjust the Mounting Lever prior to attachment to get the
Mount Lever to engage properly (see step
4 and then return to step 3 ).
3.
Tighten the Clamp Knob until the Bracket Mount is parallel to the rail.
Electro-Mechanical Hazard - Equipment damage may result.
• Before installing the Table Mount, ensure the table rail can withstand a minimum vertical
static load of 18 kg (40 lbs.) Refer to the table manufacturer documentation for weight
load information.
• Do not over tighten Table Mount knob.
• Do not force the Table Mount onto the table rail.
• Loosen Table Mount knob prior to removal of components.
NOTICE