Rev. 05 (01/2006) - SE - USE33E_Druck05.DOC
8
Key 5: ALL ON
This key is used to stop all control cycles. The timer settings are ignored
and the ultrasonic module is switched on. This mode is shown in the
display by the indication "ALL". Pressing this key again, the mode returns
to the programmed settings, whereas those lines which are
actually on remain on.
By switching the mains switch off and on, the instrument returns to the
programmed mode.
Key 6: STAND-BY
This key is used to switch the instrument to standby mode. If it is pressed
again, the active mode is restored. In the standby mode all lines are
switched off. The indication shows "OFF" and the LEDs are off.
By switching the mains switch off and on, the instrument returns to the
programmed mode.
Adjust actual day and time
If the SET TIME key is pressed while the instrument is in basic mode, the day time
can be changed by additionally pressing the key UP or DOWN, respectively. To
change the weekday go beyond midnight (24:00 hours). When all keys are released
the new adjustments for day and time will be stored.
+
or
Adjustment of the start and stop times
Having entered the programming cycle by pressing the key PROG for 5 seconds the
different positions are activated in the following sequence by pressing the UP or
DOWN key
Indication
LED
ON1
Monday
OFF1
ON2
OFF2
ON3
OFF3
ON1
Tuesday
OFF1
ON2
OFF2
ON3
OFF3