Warning: It is not a safety harness & should be worn in
conjunction with the vehicle safety belt.
1. Place the PVC backing of the harness against the
front of the seat back.
2. Pass the two top vertical fixing straps up and over
the seat back.
3.
Pass the tail-ends of the vertical fixing down through
the gap between the seat back and seat cushion and
bring them up to connect through the Aluminium Bar
Buckles of the top fixing straps
4.
Position the body harness so that the waist belt will
be in line with the waist.
5.
Tighten the vertical straps to fit the seat back as
securely as possible and pass the loose ends
through the Tri-Glide slide.
Designed to offer more postural support and a certain degree of restraint to the passenger.
This harness incorporates a
‘bib-front’ with two torso straps with anti-escape buckles. This harness will
only fit seats with access between the seat back and seat cushion.
6. With the harness unfastened at the waist belt sit the
passenger on the under-strap which is lying on the
seat cushion and bring their arms through the
shoulder straps.
7. Now bring the under-strap up between the legs and
loop it back onto the waist belt over the buckle.
8. Connect the waist belt buckle to fasten the harness.
9. Adjust all straps to fit tightly yet comfortably by
pulling the tail-ends of strapping through the adjuster
buckles.
10. To remove the passenger from the harness -
Unfasten the buckle on the waist belt at the centre-
front.
Showing how the harness is
attached to a bench seat.
IMPORTANT: BELTS AND HARNESSES SHOULD BE REPLACED IF THEY SHOW ANY SIGN OF FRAYING
OR CUTS, AND ESPECIALLY IF THEY HAVE BEEN INVOLVED IN AN ACCIDENT.