DTMF Transport Type
Reference Manual (SIP Version)
Mediatrix 1204
205
DTMF Transport Type
You can define how to transport the DTMFs.
X
To set the DTMF transport type:
1.
In the
voiceIfMIB,
set the DTMF transport type in the
voiceIfDtmfTransport
variable
(
voiceIfDtmfTransportTable
group).
The following choices are available:
G.729
voiceIfCodecG729MinPTime
Shortest packetization period allowed for the
G.729 codec. Authorized values start at 10 ms
and come in discrete steps of 10 ms up to the
one specified by the
voiceIfCodecG729MaxPTime
variable.
Default Value
: 10
10-100, with increments
of 10
voiceIfCodecG729MaxPTime
Longest packetization period allowed for the
G.729 codec. Authorized values go up to
100 ms, in discrete steps of 10 ms, and start at
the one specified by the
voiceIfCodecG729MinPTime
vartiable.
Default Value
: 100
10-100, with increments
of 10
Table 129:
Packetization Time Settings (Continued)
Variable
Definition
Values (ms)
Note:
The packetization time is not negotiated between endpoints, so a minimum and a maximum don't
make much sense. The selected value is the default RTP value (20 ms for G.711, G.726, and G.729.AB, 30
ms for G.723) if it is included in the range delimited by the minimum and maximum. Otherwise, it is the
minimum.
Standards Supported
•
draft-choudhuri-sip-info-digit-00.txt
•
RFC 2833: RTP Payload for DTMF Digits, Telephony Tones
and Telephony Signals
DTMF out-of-band
Certain compression codecs such as G.723.1 and G.729 effectively distort voice because they lose
information from the incoming voice stream during the compression and decompression phases. For
normal speech this is insignificant and becomes unimportant. In the case of pure tones (such as DTMF)
this distortion means the receiver may no longer recognize the tones. The solution is to send this
information as a separate packet to the other endpoint, which then plays the DTMF sequence back by re-
generating the true tones. Such a mechanism is known as out-of-band DTMF. The Mediatrix 1204
receives and sends out-of-band DTMFs as per RFC 2833 using RTP. DTMFs supported are 0-9, A-D, *, #.
Table 130:
DTMF Transport Type Parameters
Transport Parameter
Description
inBand
The DTMFs are transmitted like the voice in the RTP
stream.
Summary of Contents for Mediatrix 1204
