Medias Mediatrix 1204, Reference Manual

Page: 177 / 390

Setting the Location (Country) Reference Manual (SIP Version)
Mediatrix 1204 151
Setting the Location (Country)
It is very important to set variables according to the country in which the Mediatrix 1204 is used because a
number of parameter values are set according to this choice. These parameters are:
Tones
Rings
Impedances
Line Attenuations
See “Appendix D - Country-Specific Parameters” on page 311 for more information on these country-specific
settings.
You can also set these parameters via the web interface, as described in “Country Selection” on page 91 .
X
To set a country location:
1. In the telephonyMIB, locate the telephonyCountrySelection variable.
This variable indicates the current country used by the Mediatrix 1204. It can also be used to select
a caller ID standard in countries that support more than one caller ID standard.
2. Set the variable with one of the following parameters:
3. Restart the Mediatrix 1204 so that the changes may take effect.
In the Unit Manager Network Administration Manual , refer to chapter Ports Parameters , section Port
Configuration Window .t
North America 1
North America 2
1
Austria 1
Austria 2
France
Germany 1
Germany 2
2
Germany 3
UK
Italy
Spain
Switzerland
Sweden
Australia 1
Australia 2
3
Japan
Israel
Thailand
Indonesia
China
Hong Kong
Malaysia
Russia
Netherlands
Brazil
Mexico
New Zealand
uk-bellcore
uk-cca
uk-etsi-fsk
france-etsi-fsk
france-etsi-dtmf
austria-etsi-fsk
austria2-etsi-fsk
1. The North America 2 choice in the
MIB is exactly the same as North
America 1.
2. The Germany 2 choice in the MIB is
exactly the same as Germany 1. 3. The Australia 2 choice in the MIB is
exactly the same as Australia 1.