Medias Mediatrix 1204, Reference Manual

Page: 117 / 390

Miscellaneous Reference Manual (SIP Version)
Mediatrix 1204 91
• HDLC_FCS_BAD_SIG_END and
• T4_NON_ECM_SIG_END
5. Set the clear channel codec to use upon detecting a fax tone in the Preferred Clear Channel Codec
field.
This is used to decide which of the following codecs is preferred, even for voice transmissions:
• PCMU
• PCMA
• G.726 at 32 kbs
• G.726 at 40 kbs
6. Click Submit if you do not need to set other parameters.
Miscellaneous
The Misc sub-page of the Telephony page allows you to configure the country in which the unit is located.
Country Selection
It is very important to set the country in which the Mediatrix 1204 is used because a number of parameter
values are set according to this choice. These parameters are:
Tones
Rings
Impedances
Line Attenuations
See “Appendix D - Country-Specific Parameters” on page 311 for more information on these country-specific
settings. You can also set these parameters via SNMP, as described in “Setting the Location (Country)” on
page 151 .
X
To set a country location:
1. In the web interface, click the Telephony link, then the Misc sub-link.
Figure 46: Telephony – Misc Web Page
2. In the Country section, select the country in which the Mediatrix 1204 is located in the Country
Selection field.
3. Click Submit if you do not need to set other parameters.
This parameter is set for all the lines of the Mediatrix 1204. You cannot have a different country for
each line.
Note:
In clear channel, G.726 at 16 kbs and 24 kbs are not recommended for fax transmission.
2