MQ-1132 / SA Evaluation Board Users Guide
MediaQ Incorporated
Board Revision 2
Revision A
4/12/01
Preliminary
Jumpers
Reference
Type
Description
JP4, JP5
JP6, JP7,
JP8, JP9
2-pin, 1x2,
0.1” header
Power measurement jumpers for FVDD (flat panel), BVDD (Bus),
USBVDD (USB), AVDDOSC (Oscillator I/O ESD), CVDD13 (SRAM)
and CVDD24 (Core). Normal operation requires either these jumpers or
resistors R93, R94, R95, R96, R97 and R98 installed. Both jumper and
associated resistor removed when measuring power.
PLATFORM SETUP INSTRUCTIONS
The MQ-1132 / SA-1110 Evaluation Board is used in conjunction with the Intel StrongARM SA-1110
Reference Platform. The following components are required and should be included in the Intel
SA1110/SA1111 development package:
§
SA-1110 platform module (Assabet)
§
SA-1111 developer platform module (Neponset)
§
DC supply for platform
§
Compact flash Ethernet card, CF to PCMCIA adapter and crossover cable
§
Serial cable (10-pin female header to 9-pin female serial port connector)
Please note that no compact flash adaptor should be installed in the SA1110 board socket, as it will cause
damage to the card and the bus drivers used to drive the MQ1132 & SA1111 board’s bus.
Hardware Assembly
The SA-1110 platform has two 140-pin connectors, J2 and J3. J2 interfaces with the SA-1111
Development Module while J3 interfaces to the MQ-1132 evaluation board. The final assembly should
resemble the diagram below which is a side view of the Intel StrongARM platform and MQ-1132
Evaluation Board. Great care should be taken to ensure correct alignment of the sockets and plugs to
prevent damage during assembly. When removing either the MQ1132 or SA1111 boards, great care
should be taken to ensure that even pressure is asserted on both sides of the connector to prevent damage
to the Plug pins and moldings.
Power is supplied to the SA-1110 Development Board connector J10. Power for the MQ-1132 board is
supplied from the SA-1110 main 140-pin bus connector.
SA-1111 Module
SA-1110 CPU Board
MQ-1132 Evaluation Board
