User guide P9-0133-B
55 of 62
Version 2.0.5 - 2015
Medema A/S
Problem
Possible causes
Remedy
The charging lamp on
the charger does not light
up when the charger is
connected to the mains
and the Mini Crosser.
No power to the switch.
Fault in cable.
Fault in charger.
Turn the switch on.
Contact supplier.
Read the operating
instructions for the
charger.
Contact supplier.
The “ready” lamp on the
charger does not light up
even though the charger
has been on for 10-12
hours.
There has been a power
cut.
The charger is doing a
top-up charge.
There is a problem with
the batteries.
There is a fault in the
charging plug for the Mini
Crosser M1 HD.
Reconnect the charger
and repeat the charging
process.
Check again half an hour
later.
Contact supplier.
Push the charging plug all
the way in and repeat the
charging process. Read
the operating instructions
for the charger.
The “ready” lamp on the
charger lights up even
when partly discharged
batteries are connected.
The fuse in the charger
has blown.
The switch in the charging
plug is malfunctioning.
Contact supplier.
Contact suppliers - read
the operating instructions
for the charger.
The charger lamp is
showing an error.
The charging plug has not
been inserted or there is a
mains fault.
The battery voltage is too
low for charging to start.
Push the charger plug in
or contact the supplier.
Read the operating
instructions for the
charger - or contact the
supplier.
,IWKHUHLVDQHOHFWURQLFIDXOWDQXPEHURIODPSVLQWKHEDWWHU\
indicator will light up. The following table shows what they
mean.
Lamps
Causes
Remedy
1 lamp
The batteries need
charging or the
connection to a battery is
poor.
Check all connections
between the controller
and batteries. If these
DUH¿QHWU\FKDUJLQJWKH
batteries
2 lamps
Poor connection to the
motor.
Check the connection
between the motor
and controller. Contact
supplier.
3 lamps
Short-circuit between
the motor and a battery
connection.
Contact supplier - say
how many lamps are lit.
4 lamps
Not in use
5 lamps
Not in use
