3
side arm(L1)
Insert the drum module
Tighten the wing screw
Loosen the wing screw
[1]
[2] Insert textured plastic end of L-rod into tom clamp and tighten wing nuts.
Repeat for each tom clamp.
[3] Loosen wing nut on pad.
[4] Attach pads to L-rods and tighten wing nuts. Repeat for each pad.
Loosen L-rod wing nuts on tom clamps.
Attaching pads to rack
Attaching module
Attaching cymbals
Bass drum and Hi-Hat pedal
[1]
the clamp.
[2] Insert the drum module to the clamp.
[3] Tighten the wing screw on the clamp.
Loosen the wing screw on
[1]
Attach your bass drum pedal to the bass drum pad.
[2] Place the Hi-Hat pedal on the floor on your left side.
[3] Please connect the clearly marked cables from the pads to the correct inputs on the drum module, and you are ready to play!
Place the bass drum pad on the floor in the center of rack.
[1]
[2] Insert cymbal holder(short) on the left side-arm cymbal clamp.
[3] Insert cymbal holder(long) on the right side-arm cymbal clamp.
[4] Remove wing nut and felt washer from cymbal tilter.
Place cymbal pad on tilter assembly.
[5] Re-attach the felt washer and wing nut. Tighten wing nut.
Note: Cymbals are arranged as follows: 12" Hi-Hat on left-side
short arm, 12" crash on left-side boom arm, 14" ride on right-side
boom arm, 12" crash on right-side long arm.
Insert each boom cymbal arm into pillar(L1) and pillar(R1).
DD508DX_Setup_G01
14" Cymbal Pad
12" Cymbal Pads
12" Cymbal Pads
12" Cymbal Pads
Drum module
10 Drum Pad
"
11" Drum Pad
9" Tom Pads
Hi-Hat Control
Pedal
Kick pad
[2]
[1]
[2]
[3]
[4]
[1]
[2]
[3]
12"
12"
12"
14"
[1]
[1]
[2]
[3]
Wing Nut
Felt Washer
Wing Nut
Felt Washer
[4]
[5]
