Before first use
,
remove
and
dispose of
the protective cover (
¢
6-01) from the breast shield.
Wash and sanitize the pump parts and bottles following the steps 1 to 4 below.
Wash your pump parts and bottles
after each use
and sanitize the parts
once per day
after
they have been washed.
1. Disassemble
Refer to figure
¢
1 on the foldout page.
i.
Disassemble the pump into its individual parts (breast shield, connector, handle, valve head and milk bottle).
ii.
Remove the diaphragm from the handle and pull the stem out.
iii.
Remove the valve membrane from the valve head.
iv.
Separate the milk bottle, lid and bottle stand.
2. Wash
(before first use and after each use)
Rinse and wash by hand
Wash in dishwasher
or
i.
Rinse the disassembled parts with cool
water.
ii.
Clean these parts with plenty of warm,
soapy water. Use a commercially available
dish soap.
iii.
Rinse the parts with cool water for 10 to
15 seconds.
Place the disassembled parts on the top rack
or in the cutlery section. Use a commercially
available dishwashing detergent.
3. Sanitize
(before first use and once per day)
Sanitize on stovetop
Sanitize in microwave
10 min
or
(except for
the handle)
Cover the disassembled, washed parts with
water and boil at least for 10 minutes.
Use Quick Clean™ Micro-Steam™ bags* in the
microwave in accordance with the instructions
on the bags.
*Refer to local website/shops for availability in your country.
4. Dry
Allow to air-dry on a clean, unused dish towel or paper towel. Store the dry parts in a clean environment.
Do not store parts in an airtight container/bag if moist. It is important that all residual moisture dries.
8
