MED ASSOCIATES INC.
MED-APA SHUTTLE BOX PACKAGE
- 2 -
DOC-015 Rev 1.4 Copyright © 2013
CHAPTER 2
| INSTALLING INTERFACE CARDS
Drivers and Software
Refer to the Instructions for installing MED-PC, Delphi, and the hardware drivers, as well as
running the hardware configuration utility in DOC-010,
MED-PC IV User’s Manual
. If a PC was
purchased from MED Associates Inc., the software and drivers will already be installed. If
necessary, use the Hardware Configuration Utility to set user-defined options for file format, file
naming, data path, and backup.
PCI Computer Interface Card
If the computer was purchased from MED Associates, the PCI card will be factory-installed.
Otherwise, install the PCI Computer Interface Card into an available full height PCI slot in the
computer following the manufacturer’s instructions provided with the computer. When
finished, turn the computer on. The Found New Hardware Wizard should begin automatically; if
it does not, select
Start |My Computer | Control Panel | Add New Hardware
. The drivers are
located on the MED-PC® installation CD and are automatically installed with MED-PC.
Decoder Card
To install the Decoder Card first turn off the power to the interface cabinet (SG-6080D or SG-
6510D). The decoder card (DIG-700G) should be installed in the leftmost slot of the interface
cabinet. Connect an SG-210CP two-pin Molex cable from the front of the decoder card to a 28
VDC power supply in the rear of the cabinet. (See Figure 2-1.)
Figure 2-1 – 28Volt Connection to Decoder Card
SG-210CP-25 2-Pin Molex Cable