MED ASSOCIATES, INC.
PHM-104A HIGH/LOW SPEED PRECISION PUMP
MED-PC Controlled Operation
The pump can be controlled via MED-PC in two different ways. The first uses MED-PC software to set
the infusion parameters and controls the pump via the USB connector. The second uses the pump’s
default parameters and uses a 28-Volt output to turn the pump on. These methods are both described
in detail below.
USB Control Via MED-PC
This section describes controlling the pump using MED-PC. The infusion parameters are set within the
MED-PC Program, as described below.
NOTE: The PHM-104A drivers and software must be installed prior to controlling the PHM-104A via
MED-PC. Refer to | PHM-104A Driver and Software Installation for driver and software installation
instructions.
1.
Using the included USB cable, connect the
USB
port (Figure 2.3) on the pump to the USB port on the
computer that was used during the PHM-104A driver installation.
2.
Set the desired pump I.D. using the PUMP ID pushbuttons switches, shown in Figure 2.1 – Top Panel
with Syringe Loaded. (The pump ID corresponds to the Box in MED-PC).
3.
Set the FLUSH/REMOTE/TEST switch to
REMOTE
.
4.
Using the 24 VDC power supply, connect the
24 VOLTS
connector on the PHM-104A to a standard
wall outlet.
5.
Turn the PHM-104A on using the green ON/OFF switch.
6.
The sample MED-PC program included in this manual may be used as is, or customized by the user.
Please refer to the
MED-PC Programmer’s Manual
for detailed information regarding the
customization of the program.
7.
Open Trans IV icon and select
Translation
|
Translate and Compile
. Select the program(s) to use and
click
Make
. Click
OK
to start the translator, and it will automatically parse the MedState Notation
and then open to a DOS screen to compile the Pascal code. Depending on the speed of the
computer, each of these steps may not be seen. If any problems are encountered during this
process, refer to the on-screen help menu or the
MED-PC User’s Manual
, or contact MED
Associates, Inc. for assistance
8.
Open MED-PC and run the PHM-104A MED-PC application. Refer to the
MED-PC User’s Manual
for
detailed instructions.
- 10 -
DOC-187 Rev. 1.6 Copyright © 2019
Med Associates, Inc.