MED ASSOCIATES, INC.
PHM-104A HIGH/LOW SPEED PRECISION PUMP
| PUMP OVERVIEW
Chapter 2
Figure 2.1 – Top Panel with Syringe Loaded
FLUSH/REMOTE/TEST Switch
When the switch is in
FLUSH
position:
-
Continuously infuses the entire volume of the syringe to flush the infusion line.
When the switch is in
REMOTE
position:
-
Enables the MED OPERATE connector.
When the switch is in
TEST
position:
-
Completes one infusion at the default pump settings (refer to Table 3.1 - PHM-104A Control
Software User Interface, Set Default).
NOTE: These switch positions do not function when the pump is connected to the computer via the
USB connector.
PUMP ID Switches
These switches are used to set the Pump ID that may be used to identify the pump when using the
software or MED-PC.
- 2 -
DOC-187 Rev. 1.6 Copyright © 2019
Med Associates, Inc.