8
INSTALLATION
Step 1
Place the mattress flatly on the bed frame.
The inflation tube should be towards the foot end so that it can be connected to the inflation nozzles
on the pump.
Step 2
You may place a thin cotton sheet over the quilted mattress top cover.
Step 3
Hang the pump over the frame or board at the foot end of the bed using the “hangers” on the back of
the pump.
Make sure the pump is secured.
Step 4
Connect the inflation tubes from the mattress to the pump’s inflating nozzles.
Make sure they are properly attached.
NOTE!
Make sure the air hoses are not kinked or tucked under the mattress. Also check to ensure the CPR
valve is properly attached.
Step 5
Plug the power cord into an electrical outlet with grounded AC power.
This product should be grounded!
The power cord has a grounding wire with a grounding pin.
This three-wire plug must be plugged properly into an outlet and grounded as shown in the figure in
the Grounding Instructions section.
NOTE!
Before inserting the plug into the outlet, make sure the voltage is compatible. Also make sure this
product is well grounded.
Step 6
Turn on the power by pressing the power switch at the right side of the pump. Proceed to the Operation
section.
Step 7
Make sure to disconnect the pump by unplugging the power cord when it is not in use.
