mectron MICROPIEZO, Use And Maintenance Manual

Page: 129 / 262

35
CLEANING AND STERILISATION
8 CLEANING AND STERILISATION
The following tables represent only mere
indications of the cleaning and sterilisation
activity that must be ensured by the user.
For the full procedures for cleaning and
sterilisation of individual parts refer to the
Chapters referenced in the tables.
CAUTION: It is prohibited to use methods
not covered in the tables below.
Machine Core Unit, Pedal, End Part of Cord
Phase Chapter Procedure
I 8.1 Preparation
II 8.2 Manual cleaning with enzymatic detergent
Tank and Cap
Phase Chapter Procedure
III 8.3 Manual cleaning with enzymatic detergent and running water
IV 8.4 Disinfecting the Tank Irrigation Circuit
Accessories (Scaler Handpiece, Scaler Nose Cone, Inserts, Torque Wrench)
Phase Chapter Procedure
Scaler
Handpiece
Scaler
Nose
Cone
Inserts
Torque
Wrench
V
8.5.1
Manual
cleaning
Manual cleaning with
Enzymatic Detergent
Immersion into enzymatic
detergent
Ultrasonic Cleaning
8.5.2
Automatic
cleaning
Thermal-disinfector with detergent
VI 8.6
Check
cleaning
Visual inspection with Lens 2.5x
VII 8.7
Drying and
lubrication
Drying
Drying and
Lubrication
VIII 8.8 Sterilisation Packaging, Sterilisation and Storage
NOTE: Repeated reconditioning has a
minimal effect on the devices and their
accessories. The end of the service life of
the accessories is generally determined
by wear or damage resulting from use.
Mectron guarantees the integrity of its
sterilisable scaler handpieces for up to 250
reconditioning cycles.