29 - MAINTENANCE OF THE MOTOR CULTIVATOR
ATTENTION!: Effect the maintenance operations when the motor cultivator is stopped and the engine shut-down.
GENERAL STANDARDS
•
To ensure constant efficiency of the motor cultivator and increase its life, carefully comply with the maintenance
operations described in this instructions manual.
•
The intervals established for each operation must be carefully observed, otherwise it may endanger the operation
and performance of the motor cultivator.
•
It is advisable to clean the machine every week, removing all dust, mud and other dirt that may have
accumulated.
•
For lubrication of the various components use only the products indicated in this instructions manual.
•
Checking the oil level in the different machine members must be carried out with machine cold and on the flat.
•
Oil changes must be made with hot oil; this facilitates drainage and favours the removal of deposits..
•
Carefully clean the greasers before putting grease in them; clean them again when the operation is completed in
order to avoid accumulation of dust.
ENGINE AND RELATED MEMBERS
Carefully comply with the maintenance instructions contained in the respective instructions book.
TYRES
•
The inflation pressure value is shown in this instructions manual.
•
A pressure lower than normal causes irregular wear of the tread, favours wear of the sides of the tyre and may, in
extreme cases, lead to sliding of the tyre on the rim with consequent bursting of inner tube.
•
Pressure higher than normal favours skidding of the tyre on the ground, with consequent loss of traction and wear
of the tread.
•
The pressure must be checked with the tyres cold.
•
Avoid bringing the tyres into contact with oil, grease or fuel.
•
Periodically check the conditions of the tread; remove stones, nails etc., which may become embedded.
30 - USE OF INTERCHANGEABLE ACCESSORIES
For the use, in safety conditions, of the motor cultivator, is necessary use the interchangeable accessories from the
Manufacturer. Use of accessories from other Manufacturers must be approved from the Technical Office of
Manufacturer with written permit.
31 - LONG INACTIVITY OF THE MOTOCULTIVATOR
When the motor cultivator has to remain inactive for a long period of time, take the following precautions:
•
Protect the engine as indicated in the appropriate instruction book.
•
Carry out general cleaning of the machine and place it in a suitable place (neither dusty nor dump).
•
Lubricate the machine (see this instructions manual).
•
If possible, raise the machine from the ground, arranging it on suitable trestles..
•
Cover the machine with a protective tissue .
- 14 -
