T
HE
2
LEVERS PLACED ON THE HANDLEBARS
(
HANDLEBAR POS
.
1
AND POS
.
3
)
AND PTO ROD
(
POS
.
4)
USED IN THE DIFFERENT POSITIONS LET
:
•
displace the machine in quiet both with engine in motion or stop
•
operate the cutter bar with idle wheels
•
displace the machine with stop engine, cutter bar or rotary tiller but with engaged wheels
•
displace the machine by pushing, with disengaged wheels, both in front and rear with engine in
motion and cutter bar engaged or disengaged
11 – MACHINE PREPARATION
The machine is delivered packed in a cardboard box with the cutter bar and rotary tiller packed
separately, due to their dimensions In the front rotary tiller is included the foot, while the tools support where
the foot must be inserted is supplied separately, ( if You buy the rotary tiller after, You may already have the
tools support). .)
To assemble the machine proceed as follows:
- take the machine out of the box (better with another person), lower the handlebars in the desired position
and fix it with the hand-lever for handlebar locking. Once you have tightened the throttle its lever can be
placed as you prefer by pulling upwards, pushing with Your thumb the screw on the head of the throttle
itself;
FOR
MOTORMOWER
VERSION
- assemble the cutter bar to the movement with eccentric by means of 4 screws given with the machine.
- oil or grease the coupling sleeve (male) of the cutter bar to the machine
- take off the fixing pin from the mouth (female) of the machine
- insert the coupling sleeve of the cutter bar to the machine, (this will be easier with the help of another
person), ensuring that the axle of the pto shaft of the machine is at the same angle as that of the bar
movement’s shaft. Once it is fitted right to the end of the coupling sleeve, insert the pin and fix it in the
lower part with its split pin
During this operation always keep the blade covered by its protection.
Never force the joining as this could damage the centring
.
ATTENTION
The machine is supplied with tired wheels.
Tyres and wheels. These must be assembled in the correct
position as shown in the picture
Pic. 2
- 7 -