Page 2 - 10
TA3H, TA3SH & TA3.5SH
2. Safety
2.16
Responsibilities
Site management must identify possible dangers and make arrangements to eliminate them.
Site management are responsible for planning driveways around the site which will prevent the
machine from experiencing excessive slopes, soft ground or having to drive over edges
especially at an angle etc. The driveways must also avoid any other possible dangers e.g.
overhead cables, work areas etc.
The operator must make sure the machine is driven correctly at all times especially with regards
to speed, overloading, only using the machine for the intended task, not driving dumpers with a
lift-skip in the raised position etc.
2.17
Overturning
If the machine begins to overturn you must grip the steering wheel firmly allowing the seat belt
to hold you in the seat until the machine comes to rest. Do not try to jump clear of the machine
when it is overturning -the machine may crush you. The ROPS will provide protection in the event
of a roll over.
2.18
Safety Signs
Safety signs are fitted to the machine to warn of possible dangers and MUST be replaced
immediately if they become unreadable or lost.
If the machine is repaired and parts have been replaced on which safety signs were fixed new
safety signs must be fitted before the machine is put into service. Use mild soap and water to
clean safety signs - DO NOT use solvent based cleaners as they will damage safety sign
material.
ALL safety signs listed must be present on the machine and must be legible.
Summary of Contents for TA3.5SH
