Page 2 Version 2
Step 3
– Your machine comes with the knives adjusted to White Flyer Clays.
However, clay sizes can vary by manufacturer.
Check the height / clearance of the knife-edges by placing a clay in the carousel.
Rotate the carousel so that the clay starts to pass underneath the inner and outer
knife separator blades. The clay must pass freely under the knife separator
blades without binding but with the minimum of clearance. Adjust if necessary,
with 7/16” open ended wrench. The height on both the inner and outer knife edge
will need to be adjusted. Photos below show adjustment with carousel fitted, but
you can remove the carousel to make adjustment easier if preferred.
Step 4
– Now, you can lay out the battery terminals and control box at the back
of the machine. DO NOT CONNECT BATTERY AT THIS POINT.
Step 5
– Check that the ON/OFF/DISARM toggle switch on the grey control box
in the OFF position. Connect the terminals from the wire harness to the battery.
A fully charged good quality deep cycle marine battery is recommended. It is
imperative that the
Red Wire
goes to positive (+) and
Black Wire
goes to
negative (-) on the battery. Never hammer the terminals onto the post of the
battery and do not over tighten the terminals.
Step 6
– Visually check, from the rear of the machine, that the motion of the
Throwing Arm is not restricted or blocked in any way.
