PCIM-DDA06/16 User's Guide
Installing the PCIM-DDA06/16
8
If your board has been powered-off for more than 10 minutes, allow your computer to warm up for at least
15 minutes before acquiring outputting analog data with this board. This warm-up period is required for the
board to achieve its rated accuracy. The high-speed components used on the board generate heat, and it takes
this amount of time for a board to reach steady state if it has been powered off for more than 10 minutes.
Signal connections
The table below lists the board connector, applicable cables, and compatible accessory products.
Board connector, cables, and accessory equipment
Connector type
37-pin male D connector
Compatibility
Pinout identical to CIO-DDA06/16
Compatible cables
C37FF-x
C37FFS-x
DFCON-37 (D-connector, D-shell, and termination pins to construct your own
cable)
Compatible accessory products
with the C37FF-x cable or
C37FFS-x cable
CIO-MINI37
CIO-TERMINAL
SCB-37
SSR-RACK24
ENC-MINI37
Information on signal connections
General information regarding signal connection and configuration is available in the
Guide to DAQ Signal
Connections
www.mccdaq.com/support/DAQ-Signal-Connections.aspx
The I/O connector is a standard 37-pin male connector that is accessible through the PC/AT expansion bracket.
Figure 4. I/O connector pinout