Measurement Computing Data Translation DT3034, User Manual

Page: 30 / 178

Installing the Board and Loading the Device Driver
29
Inserting the DT3034 Board into the Computer
Once you have set up the expansion slots, do the following to insert the DT3034 board into the
computer:
1. Position the board so that the cable connectors are facing the rear of the computer, as
shown in
Figure 2 .
Figure 2: Inserting the DT3034 Board in the Computer
2. Carefully lower the board into the PCI expansion slot using the card guide to properly
align the board in the slot.
3. When the bottom of the board contacts the bus connector, gently press down on the board
until it clicks into place.
4. Secure the board in place at the rear panel of the system unit using the screw removed
from the slot cover.
5. Reinstall the cover of the computer. Refer to your computer’s user’s manual for
instructions.
6. Power up the computer, and follow the steps in the next section.
CAUTION:
Do not force the board into place. Moving the board from side to side
during installation may damage the bus connector. If you encounter
resistance when inserting the board, remove the board and try again.
Rear of Computer
DT3034 Board
PCI Expansion Slot Bus Connector