PB-230 Instruction
Manual
1
:
1.Make sure the charger is shut off and choosing suitable wires to connect the charger and batteries based on the rating of charging
current. The polarity must be correct: charger output (+) should be connected to the (+) terminal of batteries and charger output (-)
should be connected to the (-) terminal.
In no times should the (+) and (-) be short together or the charger and batteries will be damaged.
Assembly Procedure
2.Connect the AC input and check whether the operation of LED is correct.
(red : charging ; green : battery is full)
1.The charger should be assembled in the place with good ventilation and low moisture.
Exposure to the rain or snow is strictly prohibited.
2.Wires connecting between the charger and batteries should be as short as possible since the high voltage drop on the wires will
increase the time required to fully charge the batteries.
3.Make sure the charging voltage and charging current are suitable for the batteries you are using.
4.If the batteries need to connect in series for charging, old batteries are not suggested to be used with new ones or the lifetime of
batteries may reduce because of the unbalance charging voltage distribution on new and old batteries.
5.Please turn off the charger before connecting or disconnecting the wires.
6.The charger has a 2-year worldwide warranty, however, damages from misusing the charger will not be included in the coverage of
warranty.
Notes On Operation:
DC output connector (standard)
DC output connector (optional)
[ housing: Anderson 1327FP(red), 1327G6FP(black)
contacts: Anderson 261G2 (45A) or equivalent ]
AD1
Red(+V)
Black(-V)
PIN NO.
1,2
3,4
UNICABLE 89M103-4P or equivalent
OUTPUT
+V
-V
1
4
2
3
AD1 (optional)
1
4
2
3
115cm 5cm
FU
S
E
Please make sure the polarity of the battery is connected correctly!
WARNING :
Summary of Contents for PB-230
Page 1: ...PB 230 Instruction Manual...
