12
When there is no any PMBus command detected for 10 sec, the charger restores to the factory
default settings, that is operation = ON…etc. please refer to Tabel 8-4.
5.
Data format of IOUT_OC_FAULT_LIMIT(46h), CURVE_ICHG(B0h), CURVE_ITAPER(B3h) is as
below: (Please refer to PMBus_Specification_Part_II_Rev_1-1 for detailed information)
6.
Insert an at least 35msec delay between commands.
4.
7
.
7.1DIRECT Data Format
DIRECT format data is a two byte, two’s complement binary integer. IRECT format data may
be used with any command that sends or reads a arametric value. If a PMBus device uses
DIRECT form data, this shall be clearly described in the product literature.
Data format of VOUT_MODE, VOUT_MODE, VOUT_COMMAND, VOUT_TRIM, READ_VIN,
R E A D _ V O U T, R E A D _ I O U T, R E A D _ T E M P E R AT U R E _ 1 , R E A D _ FA N _ S P E E D _ 1 ,
R E A D _ FA N _ S P E E D _ 2 , C U R V E _ V B S T, C U R V E _ V F L O AT, C U R V E _ C C _ T I M E O U T,
C U RV E _ C V _ T I M E O U T, C U RV E _ F L O AT _ T I M E O U T i s a s b e l o w : ( P l e a s e r e f e r t o
PMBus_Specification_Part_II_Rev_1-1 for detailed information)
