Technical Manual
Glass Push-button II Smart & Push-button Smart 86 [Series .02]
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1 • Germany
Phone: +49-2263-
880 • [email protected] • www.mdt.de
7
7
2.5 Commissioning
After wiring the unit, the physical address is assigned, and the application is programmed:
(1)
Connect the programming interface with the bus, e.g. with MDT USB Interface.
(2)
Switch-on bus voltage.
(3)
Activate programming mode by simultaneously touching/pressing buttons 7 and 8 on the unit
(status LEDs on the right and left of the button light up red alternately).
(4)
Loading the physical address from the ETS software via the interface (red LED goes out as
soon as this has been successfully completed).
(5)
Loading the application, with desired parameterization.
(6)
If the device is enabled, you can test the requested functions (also possible by using the ETS-
Software).
2.6 Reload symbols
Any symbols can be reloaded into the Push-button. For this purpose, a DCA app "MDT Glass Push-
button II Smart/Push-button Smart 86" must be downloaded and installed once from the MDT
website or from the shop at my.knx.org. The images to be reloaded must fulfil the following
requirements:
•
Format: Bitmap
•
Size: 64x64 Pixels
•
Colour: Black/White
•
Using ETS5 or higher
