Technical Manual
Glass Push Button II Smart & Push Button Smart 86
MDT technologies GmbH, Geschäftsbereich Gebäudeautomation
Phone: +49-2263-880
•
Fax: +49-2263-4588
•
E-Mail: [email protected]
•
www.mdt.de
36
36
4.4 Push button functions
4.4.1 Identical parameter – Blocking object
The blocking object can be activated for both grouped buttons and single buttons. If the blocking
object is active, a communication object is displayed for the relevant button or the relevant button
pair. This means that up to 12 blocking objects can be parameterised for one push-button. If the
blocking object is assigned a logical 1, the corresponding push-button is "blocked" and can therefore
no longer be switched. A logical 0 removes the lock.
Figure 19: Identical parameter – Blocking object
The following table shows the available communication object:
Number Name
Length Usage
4
Blocking object
1 Bit
Blocks the button function
Table 23: Identical object – Blocking object
4.4.2 Identical parameter – Function name
The presentation of a button function is parameterised identically for all buttons or button pairs. The
function name
is displayed centrally above the respective function and can either be set
permanently ("via text input") or set dynamically via a communication object.
With the two-button function, the left and right buttons can also be assigned their own labelling.
The display of the symbols is described under the corresponding button functions.
The following settings are available:
ETS-Text
Dynamic range
[Default value]
Comment
Function name
no text
from „message-text“
(14 Byte object 119)
from „State text 1“
(14 Byte object 120)
from „State text 2“
(14 Byte object 121)
over text input
dynamic text according to
status value
Sets the data source for the
function name.
Selection "dynamic text according
to status value" only available for
"switching" functions
.
The function name is changed
depending on the telegram
received, e.g. "Presence/Absent"
can be signalled.
Text
free text
[up to 20 bytes allowed]
Input of the function name.
Only available for “Function name
– over text input”
Key label for left/right
push button
free text
[up to 6 bytes allowed]
Labelling of left and right button.
Only for two-button function
.
Text for “Off” / “On”
free text
[up to 9 bytes allowed]
Input of a text.
Only available for “dynamic text
according to status value”
Table 24: Identical Parameter – Function name
