MDT Technologies AKK-03UP.02, Technical Manual

Page: 20 / 78

Technical Manual Switch Actuator 3-fold, FanCoil
MDT technologies GmbH
•
51766 Engelskirchen
•
Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• knx@mdt.de • www.m
dt.de
20
4 Configuration of the operating mode
The operating mode of the device can be chosen at the general settings of the device:
Figure 4: Selection of the operating mode
According to the adjusted operating mode, the parameter and communication objects are loaded.
If the operati g ode A tuator is hose , the setti gs a d o je ts are a aila le as des ri ed i
5
Reference ETS-Parameter .
If the operati g ode A tuator is hose , the setti
ngs and objects are available as described in6
Parameter - FanCoil.
4.1 General Settings
The following table shows the general settings for the AKK-03UP.01:
ETS-text
Dynamic range
[default value]
comment
Startup timeout 0-120s
[5s]
Time between a reset and the
functional start of the device
C li „Operati g telegra

not used

2 min
–
24h
Adjustment if a
„Operati g telegra is se d
cyclic on the bus.
Day/Night object

not used

use, no read

use, read after reset
Adjustment if a Day/Night
object is used and whether it
should be read after a reset or
not.
Only used in FanCoil Mode.
Polarity of day/night object

Day = 1 / Night = 0

Day= 0 / Night = 1
Adjustment of the polarity of
the day/night object.
Table 5: General settings
The following table shows the communication objects:
Number Name Length Usage
46 Operating 1 Bit Sending a cyclic operating-telegram
47 Day/Night 1 Bit Switching between day/night mode
Table 6: Communication objects - General