MDC XT16HR EAST WEST 2022, Owner'S Manual

Page: 70 / 116

www.marketdirect.com.au
I
Ph: 1300 494 494
I
©Copyright
I P a g e | 68
Trouble Shooting
12 Volt Electrical
PROBLEM POSSIBLE CAUSE REMEDY
No power Main switch turned off Turn on main rotary switch
Tripped main circuit breaker Reset CB1 circuit breaker located with batteries (See
diagram 1)
Flat Battery Battery needs reset: Charge battery on mains power
and set charger to “Supply Mode” until voltage reaches
greater than 5 volts then return to “Lithium” mode.
Battery needs reset: If no mains power available jump
start using another 12v battery to waken DC to DC
controller and start solar panels charging.
Not charging from
mains power.
RCD has tripped Reset RCD protection on wall.
Charger not turned on Ensure charger is plugged in and power point is turned
on
Not charging from
solar
Tripped solar panel circuit
breaker/s
Check CB6 & CB7 near batteries, if black pin is
protruding from end of breaker push back in to reset.
(Diagram 1)
Tripped DC to DC breaker Check CB4. (Diagram 1)
Not charging from
vehicle
DC to DC trigger wire not
connected
See trailer plug wiring in this manual
Tripped circuit breaker Check CB5 and CB4 near the batteries and reset if
necessary (Diagram 1)
Circuit not
working
Tripped circuit breaker Check and reset the individual circuit breaker on the
control panel
240 Volt Electrical
PROBLEM POSSIBLE CAUSE REMEDY
No power Not connected to mains Connect to mains power
RCD unit has tripped Reset the RCD unit switch to up position
Site power supply tripped Check RCD on site power
10 amp converter tripped Check your 10 amp converter
Generator RCD tripped Check and reset RCD on generator