MD Helicopters CSP-900RMM-2, Servicing And Maintenance

Page: 133 / 2144

CSP − 900RMM − 2 MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 211
Revision 28
05-20-50
INSPECTION 2 − CABIN
Table 203. Inspection 2 − Cabin (Area 2)
Registration No. Serial No. Helicopter Total Hours
Model Requirement RMM Section Initial
900 Make sure you comply with applicable Special Inspections (Calendar)
for Area 2 and make entries in Log Book.
05 − 20 − 10
General
900 Fully clean helicopter as necessary before you start inspection. CSP − SPM
20 − 20 − 00
900 Refer to related manufacturers’ publications for detailed necessary
inspection of engines, starter/generators, battery and all installed STC
and optional equipment.
01 − 00 − 00
900 Examine the aircraft maintenance records for aircraft discrepancies
and correct as necessary.
N/A
900 Examine Integrated Instrument Display System (IIDS) Exceedance
Log Menu and Fault Log Menu. Record and correct discrepancies as
necessary. (NOTE: Logs may be viewed on the IIDS or refer to
GBMC User Guide for complete download and save of IIDS data).
95 − 30 − 00
900 Make sure you comply with component mandatory retirement, refer to
Airworthiness Limitation Schedule and make entries in Log Book.
04 − 00 − 00
900 Make sure you comply with component overhaul, refer to Overhaul
Schedule and make entries in Log Book.
05 − 10 − 00
900 Make sure you comply with all applicable Airworthiness Directives
and service bulletins and make entries in Log Book.
N/A
900 Make sure all placards and markings are installed. 11 − 00 − 00
900 Defuel helicopter (if necessary)
NOTE:
Make sure helicopter is defueled before you remove a cabin
floor or floor access panel. If opposite panel is left installed, either
panel AR 165 or panel LR 165 can be removed without defueling
helicopter.
12 − 00 − 00
06 − 00 − 00
900 Remove trim panels, covers, and access panels as necessary. 06 − 00 − 00
Fuselage
900 Inspect area fuselage exterior panels, and structure that is in view for
damage, deterioration, and distortion.
53 − 20 − 00
53 − 30 − 00
900 Inspect cabin floor panels for condition, damage, and attach hardware
for correct installation and security.
53 − 20 − 00
Electrical Power
900 Inspect area electrical wiring and electrical component installation for
condition, support, and security of attach hardware.
98 − 00 − 00