540-038
ETT Distribution GmbH Schmalbachstraße 16 38112 Braunschweig Nachdruck oder
Vervielfältigung nur mit ausdrücklicher Genehmigung Stand 02/ 2019
Soldering In:
Switch the temperature- and the air quantity controller to the minimum and plug the device to an
electric outlet.
Use the rotary s to adjust the desired temperature according to the table above.
After a short period of warming up the heating element is reaching its working temperature.
The temperature can be regulated any time.
Put some soldering metal on the desired spot.
Now heat up the soldering metal without touching it or any component.
After the soldering metal is melted completely switch of the device and let cooling down the soldering
joint.
Check the soldering joint for unintentional solder balls or solder bridges. These should be removed
before usage.
Clean the soldering tip properly from remains of molten soldering metal.
