863-675/-676
P2009 © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
Speaker Connection:
•
While using 2-way-speaker the impedance should not be lower than 8
Ω
per speaker. Otherwise the
speakers could be damaged.
•
Pay attention to the correct polarity while connecting the speakers.
•
Pay attention that dismantled wires don’t have contact with each other.
Operation:
•
After connecting the speakers to the amplifier plug the power supply cable [5] into an electric outlet.
•
Switch on the amplifier with POWER [3] then the display [14] will be illuminated.
•
Use INPUT [10] and choose a signal source.
•
Use MASTERVOLUME [15] to control the main volume.
•
Use DSP [4] to choose from different sound settings.
•
Use VFD [7] to choose from different display settings.
•
If a signal source is connected to AC-3/DTS INPUT [2] and all speaker outputs SURROUND SPEAKER &
MAIN SPEAKER [4] are allocated use the keys [5] for adjusting the desired ambient sound.
•
In an ambient sound system control the volume of each speaker with the keys [6].
•
Use MUTE [2] for stop the complete signal output without switching the amplifier off.
•
Use OK [5] for activating the karaoke mode including the microphone input MIC1/MIC2 [12]. To control
the volume of the microphone signal use MIC.VOL [1]. In addition the echo and the delay function
ECHO+/- and DELAY+/- [9] are active.
