McNeilus Zero Radius ZR 12 ft. Extended Reach, Operator'S Manual

Page: 90 / 118

78
© 2010 McNeilus Truck and Manufacturing, Inc.
Zero Radius Side Loader
Preventive Maintenance
3.6 Trash Behind the Packing Panel
• Daily Checks - The refuse vehicle is inspected for trash
behind the packing panel by the operator or skilled
service personnel.
When the refuse vehicle is operated on the route, trash can
pass by the packing panel. If the trash is not cleaned from
behind the packing panel, the refuse vehicle can be damaged.
1. Shut the engine off and disable the refuse vehicle.
WARNING
Packer must be disabled by the following
steps before proceeding.
1. Place transmission in NEUTRAL.
2. Apply chassis parking brake.
3. Shut engine OFF.
4. Remove chassis ignition key and maintain
in personal possession.
5. Turn chassis BATTERY switch OFF.
Failure to disable the Packer may result in
serious personal injury or death.
2. Perform your company’s Lockout/Tagout procedure.
If your company does not have a Lockout/Tagout
procedure, follow OSHA 1910.147 and 1910.146
Confined Space as appropriate.
N O T E
There are clean out doors on both sides of
the refuse vehicle. Open each door to
properly clean behind the packing panel.
3. Unhook the clamp ( Figure 40, Item 1) holding the clean
out door closed.
4. Open the clean out door ( Figure 40, Item 2).
Figure 40
1
2
5. Inspect behind the packing panel ( Figure 41, Item 1) for
accumulation for trash.