There are two Infrared (IR) emitter outputs on the rear panel. These outputs are
used to control the connected source components remotely through the
MAP-1200PRE IR system.
For example, connect an IR emitter to IR Emitter output jack of the controller,
and then connect the flasher to the IR receiver window on one of connected
sources. Now you can use the source remote control in any zone and control
your source through the keypads remotely. The keypad should have the
corresponding source selected for the IR to work. Repeat this for another
Infrared (IR) enabled sources for complete IR source control.
10
Source 2-DVD
IR Emitter from
Source 2 port
Power
IR Signal
Grounding
IR +
IR -
FRONT
BACK
reserved for cascading units
INFRARED EMITTER OUTPUTS
