60-44 Maintenance - 600 Service Hours or Twice Yearly
VX30/VX50 Gen3/ECO50 Vacuum Systems
M
AINTENANCE
- 600 S
ERVICE
H
OURS
OR
T
WICE
Y
EARLY
Wheel Bearings - Grease
Step 1:
Remove center rubber plug from the end of the grease cap.
Step 2:
Place a standard grease gun onto the grease fitting at the end of
the spindle. Ensure grease gun nozzle fully engages the fitting.
Step 3:
Pump grease into the fitting. The old displaced grease will begin
to flow back out the cap around the grease gun nozzle.
NOTICE:
Rotate hub or drum while adding grease.
Step 4:
When new clean grease is observed, remove grease gun, wipe off
any excess, and install rubber plug.
Belts - Inspect
, for belt maintenance
instructions.
• Inspect and verify the condition of belts; replace as necessary.
• Look for signs of aging such as frayed edges and cracks.
• Tighten belts if necessary.
Summary of Contents for EC050-500
