McIntosh XCS200, Owner'S Manual

Page: 8 / 20

8
4. Determine the Loudspeaker Mounting Location
on the wall, making sure the Mounting Bracket
will be anchored to a stud located inside the wall.
Note: Use extreme caution to avoid any existing
electrical wiring, plumbing, etc., located
inside the wall.
5. Refer to figures 11 thru 16 to install the appro-
priate Wall Bracket on the wall
(orient the bracket as illustrated)
using the supplied Mounting
Screws. If the Flush Mount
Bracket is used, attach the two
cone shaped rubber bumpers to
the rear of the Loudspeaker, near
the bottom.
Note: If the wall covering mate-
rial and/or thickness is dif-
ferent from the illustration,
the two supplied Mounting
Screws need to be replaced
with screws of the appro-
priate type and length.
6. Orient the Loudspeaker to line up with the Wall
Brackets and attach them together. If the angle
mount is used, install the Locking Screw to secure
the Loudspeaker at the desired angle.
7. Optionally, attach the supplied McIntosh Logo to
the Front of the XCS200 Loudspeaker Grille using
the two spring clips.
8. Align the Grille fasteners to the Loudspeaker
Grommets (four on each side). Carefully push
down to secure the Grille to the Loudspeaker.
9. Proceed to “Room Acoustics and Loudspeaker
Placement” on page 10.
Note: Retain the three removed screws and Stabi-
lizer Bar for possible future use.
3. Attach either the flush mount or angle mount
brackets to the rear of the Loudspeaker. Refer to
the chart below, along with figures 5 and 7 for the
screw location. Also, be sure to orient the bracket
as illustrated in figures 8, 9 and 10.
Note: The Angled Bracket is only for vertical
mounting of the XCS200 Loudspeaker.
XCS200 Screw Removal for Wall Mounting
Mounting Type Screws - V Screws - H
Vertical Flush Mount Remove -----
Vertical Angle Mount Remove -----
Horizontal Flush Mount ----- Remove
1. Carefully remove the Grille from the Front of the
Loudspeaker by lifting it up at the edges and place
it in a safe place.
2. Using an appropriate tool, remove the three
screws securing the Stabilizer Bar to the back of
the XCS200. Refer to figure 6. Replace the just
removed screws with the supplied Stabilizer Bar
Replacement Screws as indicated as Location-R.
Refer to figures 5 and 7.
The supplied On Wall Mounting Brackets allow for
three different mounting positions of the XCS200
Loudspeaker relative to the wall, both vertical and
horizontal. Two positions are flush mount, with the
Loudspeaker close to and parallel with the wall. The
other position is angle mount, which places the Loud-
speaker further away from the wall and allows for
rotation of ± 30 Degrees. Refer to figure 5.
Installing the XCS200 on the Wall
Figure 6
Stabilizer Bar Screws
Stabilizer Bar
7
-3/4
"
19.7cm
23
-3/4
"
60.3cm
5
-5/16
"
13.5cm
Rear View
of the
XCS200
Screws - H
Screws - H
Screws - V Screws - V
Location R
Location R
Location R
Figure 7
Figure 5
Loudspeaker Bracket
Locking
Screw
Wall Bracket
Horizontal Wall Mounting
Angled Hardware
Vertical and Horizontal
Wall Mounting
Flush Hardware
Wall Bracket
Loudspeaker Bracket
Wall Mounting Screws
Stabilizer Bar
Replacement Screws