PERFORMANCE SPECIFICATIONS
2
1. The heavy notes on the schematic denote the primary
signal path.
2. Unless otherwise noted, all voltages indicated on the
schematics are measured under the following conditions:
a. AC input at 120 volts, 50/60Hz.
b. All voltages are +/-10% with respect to ground. A
high impedance (10 megaohm) voltmeter must be used.
3. Unless otherwise specified:
a. Resistor values are in ohms.
b. Capacitor values are microfarads (uF).
c. Inductor values are in microhenries (uH).
4.
On PC board drawings, Square pad indicates:
a. Polarized Capacitors - Positive
b. Diodes - Cathode
c. Others - Pin 1
5.
WARNING
Parts marked with the symbol have critical
characteristics. Use only replacement parts recom-
mended by the manufacturer.
MusicBank
TM
is a registered trademark of the Nakamichi Corporation
NOTES
Frequency Response
+0, -0.5dB from 5Hz to 20,000Hz
Signal To Noise Ratio
108dB (IHF A-weighted
)
Dynamic Range
100dB
Harmonic Distortion
0.002%
Channel Separation
105dB
Maximum Output Level
2.0Vrms Balanced
2.0Vrms Unbalanced
Output Impedance
600 ohms Balanced
600 ohms Unbalanced
Sampling Frequency
44,100Hz
D/A Converter
24-bit dual converters with 8 times over sampling digital
filter
Error Correction
CIRC
Quantization
16-bit linear
Digital Output
Optical: -15dBm to –21dBm
Coaxial: 0.5v p-p/75 ohm
Transport Signal Readout Type
Semiconductor Optical Laser
Disc Rotational Velocity
200 to 500rpm (constant linear velocity)
Wow and Flutter
Below current measurement limits
Power Requirements
100 Volts, 50/60Hz at 25 watts
110 Volts, 50/60Hz at 25 watts
120 Volts, 50/60Hz at 25 watts
220 Volts, 50/60Hz at 25 watts
230 Volts, 50/60Hz at 25 watts
240 Volts, 50/60Hz at 25 watts
Note: Refer to the rear panel of the MCD205 for the
correct voltage.
Dimensions
Front Panel: 17-1/2 inches (44.5cm) wide, 5-3/8
inches (13.7cm) high. Depth behind front
mounting panel is 15 inches (38.1cm) including
clearance for connectors. Panel clearance required
in front of mounting panel is 3/4 inch (1.9cm).
Note: When a CD Disc is inserted or ejected,
the panel clearance required in front
of mounting panel is 3-3/4 inches (9.5cm).
Weight
21 pounds (9.5kg) net, 35 pounds (15.9kg) in
shipping carton
Summary of Contents for MCD205
