21
Mute
Press the MUTE Push-button, on the C48 Front Panel
or on the Remote Control, to Mute the Audio in all
outputs (Main, Output 1, Output 2 and Headphones)
except the REC OUTPUT. The Front Panel Informa-
tion Display will indicate the Source Name and the
word MUTE in place of the actual volume setting.
Refer to figure 68.
Pressing the Mute Push-button a second time or
adjusting the volume control (either the Front Panel or
Remote Control) will un-mute the C48.
Output 1 and 2
Press the Front Panel OUTPUT 1 / OUTPUT 2
Push-button or use the Remote Control and press the
SETUP/BLUE Push-button followed by the OUTPUT
1 / OUTPUT 2 Push-button to send audio to sepa-
rate Power Amplifiers connected to the rear panel
OUTPUT 1 or 2 Jacks. It also activates the POWER
CONTROL OUTPUT 1 /OUTPUT 2 Jacks on the rear
panel of the C48. To stop the Audio and Power Control
Signals from going to the separate Power Amplifiers,
press the same Push-button(s) a second time.
Headphones Jack
Connect a pair of dynamic headphones to the Head-
phones Jack with a 1/4” (0.635cm) stereo phone type
plug for private listening. Press OUTPUT 1 and/or 2
Push-buttons to mute the Loudspeakers.
Note: The Headphone Output is optimized for imped-
ances ranging from 100 to 600 ohms.
How To Make a Recording
1. Select the desired signal source you wish to record
by using the Front Panel INPUT Control or the
appropriate Source Push-button on the Remote
Control.
2. Adjust the record level using the recorder level con-
trol and proceed with the recording process.
3. Listen to the playback of the program source just
recorded by selecting the Input Source connected to
the recorder component output.
Figure 68
SOURCE: CD1
MUTE
Figure 50
How to Operate the C48, con’t
Summary of Contents for C48
Page 24: ...24 ...
Page 25: ...25 Photos ...