5. Install the Mounting Strips.
In the hardware package you will find two mounting
strips, four 6-32 x 1-1/4 inch fillister head screws and
two 4-40 x 1-1/4 inch flat head screws. These are long
enough for any cabinet panel thickness up to one
inch.
Starting at the right-hand side of the panel, insert a
4-40 x 1-1/4 inch flat head screw into the center hole in
the panel, marked B on the template. On the back of
the panel, align a mounting strip with the holes in the
panel and tighten the screw until the screwhead is
pulled slightly into the wood.
Repeat this procedure to attach the mounting strip
to the left side of the panel.
6. Attach the PANLOC Brackets.
Using two of the 6-32 x 1-1/4 inch fillister head screws
in the A holes on each side, attach the PANLOC
brackets to the cabinet panel; the short flange is
mounted against the front (face) of the cabinet panel.
The screws pass through the PANLOC bracket flange,
the cabinet panel, and then through the mounting
strips previously mounted.
7. Install the Instrument.
Guide the AC power cord through the panel opening
to the back of the cabinet; then, slide the instrument
into the opening carefully so that the rails on the bot-
tom of each side of the chassis engage the tracks on
the mounting brackets. Continue to slide the instru-
ment into the cabinet until it is stopped by the adjust
position latches. Press the latches inward, this per-
mits the instrument to slide into the cabinet until its
front panel is flush with the cabinet panel. Depress
the PANLOC buttons at the lower left and right cor-
ners of the instrument panel to lock the unit firmly in
the cabinet. Depressing the PANLOC buttons again
will unlock the instrument so that it can slide forward
to the adjust position; if you press inward on the ad-
just position latches then you can remove the instru-
ment from the cabinet.
-3-
