10
Specifications
Specifications
Power Output Stereo
350 watts into 2, 4 or 8 ohm loads is the minimum sine
wave continuous average power output per channel both
channels operating.
Power Output Mono Parallel
700 watts into 1, 2 or 4 ohm loads is the minimum sine
wave continuous average power output.
Output Load Impedance
2, 4 or 8 ohms (Stereo Mode)
1, 2 or 4 ohms (Mono Mode)
Rated Power Band
20Hz to 20,000Hz
Dynamic Headroom
2.1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Total Harmonic Distortion
0.005% maximum at any power level from 250 milliwatts
to rated power per channel from 20Hz to 20,000Hz, all
channels operating.
Intermodulation Distortion
0.005% maximum if instantaneous peak output per channel
does not exceed twice the rated output with all channels
operating for any combination of frequencies from 20Hz to
20,000Hz.
Signal To Noise Ratio
(A Weighted)
85dB Unbalanced (116dB below rated output)
115dB Balanced (124dB below rated output)
Sensitivity
1.9 Volts Unbalanced Input
3.8 Volts Balanced Input
Input Impedance
20,000 ohms Unbalanced
40,000 ohms Balanced
Damping Factor
Greater than 40
Power Requirements
100 Volts, 50/60Hz at 14.5 amps
110 Volts, 50/60Hz at 13.0 amps
120 Volts, 50/60Hz at 12.0 amps
220 Volts, 50/60Hz at 6.50 amps
230 Volts, 50/60Hz at 6.25 amps
240 Volts, 50/60Hz at 6.00 amps
NOTE: Refer to the rear panel of the MC352 for the correct
voltage.
Dimensions
Front Panel: 17.50 inches (44.5cm) wide, 8.89 inches
(22.58cm) high. Depth behind front mounting panel is 21
inches (53.3cm) including clearance for connectors. Panel
clearance required in front of mounting panel is 1.125
inches (2.9cm).
Weight
105 pounds (47.63Kg) net, 138 pounds (63Kg) in shipping
carton
