McHale
991L
Round Bale Wrapper
48
Continuous Cycle
The Continuous Cycle, when enabled, allows the wrapping machine to complete the
wrapping cycle without waiting for the operator to press Table Tip (Button 7) to start the
tipping part of the cycle. Every time the Electronic Control Box is switched on, it asks
the operator to press Enter (Button 3) to confirm that the Continuous Cycle is required.
To turn the continuous cycle On/Off:
1.
Press the Down Arrow (Button 4) three times, to select the Operator Setup
Menu
2.
Press Enter (Button 3)
3.
Press the Down Arrow (Button 4) five times and press Enter
4.
Use the Up and Down Arrows (Buttons 1 & 4) to select On/Off
5.
Press Enter (Button 3) to save the new setting
Auto Load Setup
The Auto Load feature, when selected, enables automatic loading of the bale. The
loading arm normally sits at the preset float position. On approaching the bale, “Auto
Start” (Button 14) is pressed, the loading arm drops to the preset lower position and the
machine is moved forward to receive the bale. “Auto Start” is pressed again; the
loading arm lifts the bale onto the wrapping table, the arm lowers to the float position
and wrapping starts. Both the float position and the lower position may be adjusted. To
set the Lower/Float Position:
1.
Press the Down Arrow (Button 4) three times, to select the Operator Setup
Menu
2.
Press Enter (Button 3)
3.
Press the Down Arrow six times
4.
Press Enter to move to the Select Auto Load Screen
5.
Press the Down Arrow (Button 4) once to select the Lower Position or twice to
select the Float Position
6.
Using the Bale lift arm down (Button 15) and Bale lift arm up (Button 16),
move
the arm to the desired position (Lower/Float). When it is correct, press Enter
(Button 3) to store the setting for the current position and press the Up Arrow
(Button 1) to return to the Select Auto Load Screen
7.
When both settings are correct, press Enter to move to the Auto Load Screen
and change the setting to ON.
More accurate settings can be achieved if the adjustments are done as the arm is
moved from a higher to a lower position. Every time the Electronic Control Box is
switched on the operator must press Enter (Button 3) to confirm that the Auto Load
Cycle is required.
CAUTION: Do not use the continuous cycle on hilly terrain
The continuous cycle should not be used in hilly terrain as the operator
needs better control of bale unloading i.e. the bale should be unloaded
on level ground.
