McHale
Fusion Vario
Baler & Wrapper
47
6.3 Care of the net wrapping system
Before operating the machine, ensure that the following procedure is followed to
ensure improved netter operation:
Clean off rubber and metal feed rollers and check for any tacky material
Once roller cleaning is carried out, ensure to apply talcum powder to the
rubber feed roll
6.4 Loading & operating the netter system
The passage of net through the netting unit is monitored; if
the net breaks or does not feed, or if the roll of net runs out,
then the alarm sounds, the
net error symbol
is displayed
in the control box display and the cycle is halted.
The following is the procedure for changing a roll or fitting the first roll:
NOTE: Cleaning solvents
Never use cleaning agents such as benzene, petrol, turpentine oil or
similar cleaning solvents to clean rubber feed roll, otherwise damage
may occur!
McHale
recommend using either of the following:
A cloth soaked in dish washing liquid
Soapy water
CAUTION: Heavy net rolls should be handled by two people
Pay attention to the heavy weight of the net roll. It is recommended that
full net rolls should be handled by two people.
CAUTION: Use protective gloves
Use protective gloves for any manual work in this area! Beware of sharp
knife edges.
WARNING: Always think 'Safety First'!
Ensure the PTO is disengaged, the tractor is shut down and ignition key
has been removed.
