McDATA OPENconnectors, Command Line Interface Manual

Page: 19 / 170

Introduction
Entering Command Line Interface Commands
1
1-5
&RPPDQG7UHH
The command tree of the CLI begins from the root. The commands in
the four extended branches (config, maint, perf, and show) are
described in
Chapter 2 , CLI Commands .
There are three additional commands (login, logout, and
commaDelim) that are globally available commands. These
commands are described in this chapter.
The hierarchy from the root, reading from left to right, is as follows.
Table 1-2
CLI Command Tree
config -------------------- features ----------------- installKey
enterpriseFabMode
ficonms
OpenSysMS
show
ip-------------------------- ethernet
show
port ----------------------- blocked
extDist
fan
name
speed
type
show
security ----------------- fabricBinding ----------- activatePending
addMember
clearMemList
deleteMember
replacePending
setFabBindState
showActive
showPending
portBinding ------------- bound
wwn
show
switchBinding ---------- addMember
deleteMember
setSwitchBindState